A sample of air was collected on a day when the total atmosphere pressure was
592 mmHg. The sample contained only oxygen and nitrogen gas. If the oxygen in the sample had a pressure of 261 mmHg, how much pressure did the nitrogen
have? NOTE: You must show your calculation on the attached scratch paper,
including which of the Gas Law formulas you used. *
A. 853 mm Hg
B. 0.206 mm Hg
C. 4.76 mm Hg
D. 331 mm Hg
(Please show your work)

Answer:

Helium has the most number of mol out of all the options and will thus have the highest number of atoms.

Explanation:

Answer:

Measure 2.47 mL of the stock solution (i.e 0.0405 mM) and dilute it to the 100 mL mark with water

Explanation:

To make 100 mL of 0.001 mM solution from 0.0405mM solution, we need to determine the volume of 0.0405mM solution needed. This can be obtained as follow:

Molarity of stock (M₁) = 0.0405 mM

Volume of diluted (V₂) = 100 mL

Molarity of diluted solution (M₂) = 0.001 mM

Volume of stock solution needed (V₁) =?

M₁V₁ = M₂V₂

0.0405 × V₁ = 0.001 × 100

0.0405 × V₁ = 0.1

Divide both side by 0.0405

V₁ = 0.1 / 0.0405

V₁ = 2.47 mL

Therefore, to make 100 mL of 0.001 mM solution from 0.0405mM solution, measure 2.47 mL of the stock solution (i.e 0.0405 mM) and dilute it to the 100 mL mark with water.

Answer:

75300g ..........................

Answer:

immma send you the link friend me on hereExplanation:

Answer: about one month

Explanation:

Answer:

a)

Explanation:

Osmosis is a process in which there is movement of solvent molecules through a semipermeable membrane to wards the higher concentration of solute or lower concentration of solvent from a lower concentration of solute molecule. Osmosis can occur in different liquids and even in gases.

Also, in osmosis knowing the osmotic pressure can help determine the molar mass of a solute dissolved in a solvent.

Answer:

[tex]T_F=-4.4\°C[/tex]

Explanation:

Hello there!

In this case, according to the given information, it is possible for us to calculate the freezing point of an aqueous solution of potassium sulfide by using the following equation:

[tex]T_F=T_{solv}-i*m*Kf[/tex]

In such a way, we firstly calculate the molality of this solution according to:

[tex]m=\frac{\frac{13g}{110.262 g/mol} }{0.150kg} =0.79m[/tex]

Finally, since the Van't Hoff's factor for K2S is 3, the freezing point of the solution turns out to be:

[tex]T_F=0\°C-3*0.79m*1.86\°C/m\\\\T_F=-4.4\°C[/tex]

Regards!

Answer:

when concentration increases, particles colide more often

The statement "When concentration increases, particles collide more often" is correct.

A constituent's abundance divided by the entire volume of a combination is known as concentration. Mass concentration, molar concentration, number concentration, and volume concentration are all examples of mathematical descriptions.

There are much more reactant particles travelling together as the concentration of reacting species increases. Because there would be more collisions, the reaction rate will be faster. The rate of a reaction increases as the concentration of reactants increases.

To know more about concentration click here.

https://brainly.com/question/10725862.

#SPJ2

Answer:

The major product from this reaction is 4-bromobenzene diazonium chloride.

Explanation:

The reaction of p-bromoaniline with HNO2 and HCl produces diazonium salt. When primary aromatic amines are nitrosated with nitrous acid in the presence of a strong acid such as HCl, diazonium salts are frequently formed. The diazonium salts are a crucial step in the production of halides and azo compounds. The necessary reaction mechanism is depicted in the illustration in the diagram below.

Explanation:

a) 3Pb(NO3)2 + Al2(SO4)3 ---> 3PbSO4 + 2Al(NO3)3

Double displacement

b) 2Cl2 + 3O2 ---> 2Cl2O3

Synthesis

c) 2Fe2O3 + 3C ---> 4Fe + 3CO2

single displacement

Answer:

Decreases.............

Answer:

kinetic energy of the particles decreases

Explanation:

just remember, cold = decrease and hot = increase

Answer:

materials or substances such as minerals, forests, water, and fertile land that occur in nature and can be used for economic gain.

Explanation:

Answer:

625 mL

Explanation:

From the question given above, the following data were obtained:

Volume of stock solution (V₁) = 250 mL

Molarity of stock solution (M₁) = 5 M

Molarity of diluted solution (M₂) = 2 M

Volume of diluted solution (V₂) =?

The volume of the diluted solution can be obtained by using the dilution formula as illustrated below:

M₁V₁ = M₂V₂

5 × 250 = 2 × V₂

1250 = 2 × V₂

Divide both side by 2

V₂ = 1250 / 2

V₂ = 625 mL

Therefore, the volume of the diluted solution is 625 mL.

Answer:

Any element in group 18 has eight valence electrons (except for helium, which has a total of just two electrons

Answer:

V₁ = 8.75L

Explanation:

P₁ × V₁ = P₂ × V₂

15atm × V₁ = 25atm × 5.25L

V₁ = 8.75L

Answer:

Eukaryotic cells have a true nucleus, which means the cell's DNA is surrounded by a membrane. Therefore, the nucleus houses the cell's DNA and directs the synthesis of proteins and ribosomes, the cellular organelles responsible for protein synthesis.

Ribosomes are the sites in a cell in which protein synthesis takes place. ... Within the ribosome, the rRNA molecules direct the catalytic steps of protein synthesis — the stitching together of amino acids to make a protein molecule.

Answer:

Explanation:

YONG ISA PO ETO HINDI KO PO ALAM TOH

Answer:

Due to the iron inside the earth.

Explanation:

Imagine a sphere of Iron, as big as two-third the size of the moon and as hot as 5700 Kelvin. That is the Earth’s core.

The iron core isn't in its liquid form even at that temperature because it is crushed under immense gravity. This core is surrounded by 2000 km of other metals like iron and nickel which are in their molten state.

The temperature is not the same at every point in this molten layer. The hotter and less dense matter rises up, and the warm denser matter sinks. This causes convectional currents in the interior of the Earth.

Because of the Earth’s spin, there is a force that is established called the Coriolis force which causes swirling whirlpools here too.

This flow of molten metals produces electric currents which generate self-sustaining magnetic fields. And as a result of the Coriolis force, all these combined effects add up to produce one big magnetic field engulfing the Earth aligned in one direction.

Answer:

Geocentric is a description that says all objects, including the moon, sun and stars orbit around the Earth.

Heliocentric is a description that says all objects including the moon, Earth and stars revolve around the sun.

Most textbooks would tell you that the current system is heliocentric.

Answer: 47.5

Explanation:

Answer: 47.5 is your answer

Explanation:

good luck on the rest XoXo

Answer:

I would put the final answer choice: "Scientists must first develop certain technologies before missions can be completed"

Explanation:

The first option is partially true, but we have ways around it.

The second option is straight-up false.

The third option doesn't make much sense, how can one work with technology that will be developed in the future and doesn't yet exist?

Therefore, the fourth option is the best.

Hope this helps

-cyber

Answer:

Pangaea

FILLER FILLER FILLER

Answer:

Amines ketones aldehydes and aromatic

Explanation:

my opinion but thats my answer

Answer:

6.00%

Explanation:

Step 1: Given data

Accepted value for the number of calories in a Bananas Foster: 300 calories

Measured value for the number of calories in a Bananas Foster: 318 calories

Step 2: Calculate the percent error in the measure

We will use the following expression.

%error = |accepted value - experimental value|/ accepted value × 100%

%error = |300 cal - 318 cal|/ 300 cal × 100% = 6.00%

Answer:

C

Explanation:

sorry if im wrong!!