Consider the following physical properties and fill in the missing information.

Answer:

T=PV/nR

Explanation:

PV=nRT then you just move them

Answer:

C

Explanation:

Answer:

2.33M

Explanation:

1. First, make sure the equation is balanced. In this case it would be HNO3+NaOH --> NaNO3 + H2O. (it is already balanced here.)

2. Find the initial volume, final volume, the volume of acid, volume of NaOH.

      a. Initial Volume: 4.85 mL

      b. Final Volume: 43.69

      c. Acid (HNO3) Volume: 5 mL

      d Volume NaOH: Initial V - Final V --> 43.69 mL - 4.85 mL = 38.84 mL NaOH

3. Find moles of NaOH reacted using the volume from D. Convert this volume into Liters. Multiply the volume of NaOH by molarity of NaOH given to you before. (.30 M NaOH)

      a. x mol NaOH/ .03884 L = .30 mol NaOH/ 1 mol = .011652 mol NaOH

4. Now find the moles of acid. The acid given to you in the equation is HNO3. The .011652 mol NaOH is from the moles reacted that you just found. The moles on the right side would be the co-efficient in front of the elements in the equation. Since this equation does not have any coefficients (it's already balanced), it would just be 1.

      a.  .011652 mol NaOH/ x mol HNO3 = 1 mol NaOH/ 1 mol HNO3.

                       x = .011652 mol HNO3

5. Now find the concentration, also known as molarity. Divide the .011652 mol by the volume of acid you have been given (5 mL). Before using 5 mL, divide it by 1000 to get the Liter form.

     a. .011652 mol HNO3/ .005 L = 2.3304 M HNO3

I hope you understand now. God bless!

Answer:

c: The equilibrium position will shift away from what was added to lower its concentration.

Explanation:

Answer: C. The equilibrium position will shift away from what was added to lower its concentration.

Explanation:

If we have a system that is already in equilibrium, the addition of an extra amount of one of the reactants or one of the products throws the system out of equilibrium. Either the forward or the reverse reaction will then occur to restore equilibrium conditions.

Answer:

Acid

Explanation:

Answer:

0.74

Explanation:

this is the correct answer. I followed a correct answer that had the same probelm with different values, swithxed it with mine, and got 0.75. So its basically 0.74

Answer: The heat energy absorbed by the glass window is 84420 J.

Explanation:

Given: Mass = 15.0 kg (1 kg = 1000 g) = 15000 g

Specific heat capacity = [tex]0.840^{o}C[/tex]

Initial temperature = [tex]20^{o}C[/tex]

Final temperature = [tex]26.7^{o}C[/tex]

Formula used to calculate heat energy is as follows.

[tex]q = m \times C \times (T_{2} - T_{1})[/tex]

where,

q = heat energy

m =  mass of substance

C = specific heat capacity

[tex]T_{1}[/tex] = initial temperature

[tex]T_{2}[/tex] = final temperature

Substitute the values into above formula as follows.

[tex]q = m \times C \times (T_{2} - T_{1})\\= 15000 g \times 0.840J/g^{o}C \times (26.7 - 20.0)^{o}C\\= 84420 J[/tex]

Thus, we can conclude that heat energy absorbed by the glass window is 84420J.

Answer:

Both

Explanation:

Please mark brailiest

Answer:

A shark is both

Explanation:

Answer:

When an element replaces another in aone element or ion within a compound is exchanged with another element or ion , the reaction is called 

The answer should be sex cell.

Answer:

Explanation:

To solve this problem we have to find the moles of iron(II) chloride that react. Using the chemical equation, we can kknow moles FeCl2 = Moles FeCO3. Thus, we can find the moles of FeCO3. Converting these moles to grams using its molar mass -Molar mass FeCO3: 115.854g/mol-

Moles FeCl2 = Moles FeCO3:

1.24L * (2.00mol / L) = 2.48 moles FeCl2

Mass FeCO3:

2.48mol * (115.854g / mol) =

Answer:

its 287

Explanation:

i got it right on edm

Answer: Concentration of the acid is 0.551 M.

Explanation:

Given: [tex]V_{1}[/tex] = 71.1 mL,      [tex]M_{1}[/tex] = 0.695 M

[tex]V_{2}[/tex] = 89.7 mL,           [tex]M_{2}[/tex] = ?

Formula used to calculate the concentration of acid is as follows.

[tex]M_{1}V_{1} = M_{2}V_{2}[/tex]

Substitute the values into above formula as follows.

[tex]M_{1}V_{1} = M_{2}V_{2}\\0.695 \times 71.1 mL = M_{2} \times 89.7 mL\\M_{2} = 0.551 M[/tex]

Thus, we can conclude that concentration of the acid is 0.551 M.

Answer: a

Explanation:

Answer:

The amount of HC₂H3₃2(aq) in the flask after the addition of 5.0mL of NaOH(aq) compared to the amount of HC₂H₃O₂(aq) in the flask after the addition of 1.0mL is much smaller because more HC₂H₃O₂(aq) is required to react with 5.0 mL NaOH than with 1.0 mL NaOH.

Explanation:

Equation of the reaction between acetic acid, HC₂H₃O₂(aq) and sodium hydroxide, NaOH(aq) is given below:

CH₃COOH (aq) + NaOH (aq) ----> CH₃COONa (aq) + H₂O

The equation of the reaction shows that acetic acid andsodium hydroxide will react in a 1:1 ratio

Since the concentration of NaOH was not given, we can assume that the concentration is 0.01 M

Moles of NaOH in 5.0 mL of 0.01 M NaOH = 0.01 × 5/1000 = 0.00005 moles

Moles of NaOH in 1.0 mL of 0.01 M NaOH = 0.01 ×1/1000 = 0.0001 moles

Ratio of moles of NaOH in 5.0 mL to 1.0 mL = 0.00005/0.00001 = 5

There are five times more moles of NaOH in 5.0 mL than in 1.0 mL and this means that 5 times more the quantity of HC₂H₃O2(aq) required to react with 1.0 mL NaoH is needed to react with 5.0 mL NaOH.

Therefore, the amount of HC₂H₃O2(aq) in the flask after the addition of 5.0mL of NaOH(aq) compared to the amount of HC₂H₃O₂(aq) in the flask after the addition of 1.0mL is much smaller because more HC₂H₃O₂(aq) is required to react with 5.0 mL NaOH than with 1.0 mL NaOH.

Answer:

47.6°C is the change of temperature

Explanation:

To solve this question we must use the equation of specific heat of a material:

Q = m*ΔT*S

Where Q is heat applied = 90J

m is the mass of the substance = 15g gold

ΔT is change in temperature = Our incognite

S is specific heat of the material = 0.126J/g°C for gold

Replacing:

90J = 15g*ΔT*0.126J/g°C

90J/15g*0.126J/g°C = ΔT

ΔT = 47.6°C is the change of temperature

Answer: Strong acid vs weak acid

Strong acids and strong bases refer to species that completely dissociate to form ions in solution.

Explanation: By contrast, weak acids and bases ionize only partially, and the ionization reaction is reversible. Thus, weak acid and base solutions contain multiple charged and uncharged species in dynamic equilibrium.

Explanation:

Explanation:

Tha Symbol of gold is Au.

Answer:

symbol of gold is Au

------------------------------------------------

Answer:

D

Explanation:

Answer:

step 2

Explanation:

ofcourse rocks dont melt

maybe lol

Answer:

Explanation:

In a redox reaction, the species which is oxidized acts as the reducing agent.

In a redox reaction, The substance losing electrons is the reducing agent and is being oxidised. The substance that gains electrons is the oxidising agent and is being reduced.

An oxidising agent isdefined as a substance that causes oxidation by accepting electrons and thus becoming reduced.

A reducing agent is defined as a substance that reduces by losing electrons and thus becomes oxidised.

Substances that have the ability to oxidise other substances are referred to as oxidising agents or oxidants

Substances that have the ability to reduce other substances are referred to as reducing agents or reductants.

To know more about Redox reaction

brainly.com/question/13293425

#SPJ2

The question should be

Which species is the reducing agent in a redox reaction?

Answer:I think it would be D.

Explanation:The law of conservation of mass states that matter cannot be created or destroyed in a chemical reaction. For example, when wood burns, the mass of the soot, ashes, and gases equals the original mass of the charcoal and the oxygen when it first reacted. So the mass of the product equals the mass of the reactant.

Answer:

ELECTROMAGNETIC SPECTRUM. Radios, televisions, mobile phones, and radar use signals made up of electromagnetic waves. These are waves that carry energy as electricity and magnetism at the speed of light. Light we can see is also an electromagnetic wave, but other types of electromagnetic wave are invisible.

Explanation:

~Hope this helps

Answer:

The sexual phase, called the gametophyte generation, produces gametes, or sex cells, and the asexual phase, or sporophyte generation, produces spores asexually. In terms of chromosomes, the gametophyte is haploid (has a single set of chromosomes), and the sporophyte is diploid (has a double set

Answer:

Gametophyte generation

Answer:

B). The smallest part of matter still retaining chemical properties.

Answer:

Metal has an high capacity, which allows it to heat up faster and transfer the heat to the contents of the pot or pan.

Explanation:

Because metal pots are made from a narrow range of metals because pots and pans need to conduct heat well.