How do i describe endothermic and exothermic changes in matter?

Answer:

it could harbor dangerous chemicals that damage the car if released

it could be holding parts together

it could have something dangerous inside

Answer:

160 grams is equal to 160,000 milligrams.

Explanation:

Please like and mark brainliest!

Hope it helps!

Answer:

1g=1000mg

160g=160000

Answer:

The top answer

Answer:

exothermic

Explanation:

heat/energy is released when it burns.

Answer:

1:1

Explanation:

Based on Avogadro's law, the volume of an ideal gas is directly proportional to the moles (Or number of molecules) presents of this gas under constant temperature.

The volume of the gas is independent to the nature of the gas

Using this law, we can change the state as:

X number of molecules of CO₂ in X number of molecules of CH₄ (Because are occupying the same volume). That means the ratio of molecules is:

Diffraction occurs whenever a portion of a wavefront is obstructed by some opaque object.

Answer:

–99 °C

Explanation:

From the question given above, the following data were obtained:

Initial pressure (P₁) = 1.5 atm

Initial temperature (T₁) = 25 °C

Final pressure (P₂) = 1 atm

Change in temperature (ΔT) =?

Next, we shall determine the final temperature. This can be obtained as follow:

Initial pressure (P₁) = 1.5 atm

Initial temperature (T₁) = 25 °C + 273 = 298 K

Final pressure (P₂) = 1 atm

Final temperature (T₂) =?

P₁/T₁ = P₂/T₂

1.5 / 298 = 1 / T₂

Cross multiply

1.5 × T₂ = 298

Divide both side by 1.5

T₂ = 298 / 1.5

T₂ = 199 K

Converting 199 K to °C, we have:

T(°C) = T(K) – 273

T₂ = 199 – 173

T₂ = –74 °C

Finally, we shall determine change in temperature. This can be obtained:

Initial temperature (T₁) = 25 °C

Final temperature (T₂) = –74 °C

Change in temperature (ΔT) =?

ΔT = T₂ – T₁

ΔT = –74 – 25

ΔT = –99 °C

Thus, the change in the temperature is –99 °C

Answer:

1st Diagram (at the left) → Mid-Atlantic Ridge

2nd Diagram (at the right) → Andes Mountains

3rd Diagram (below) → San Andreas Fault

Explanation:

I have been able to label the diagram with the correct information.

The 1st diagram at the left is the Mid-Atlantic Ridge. This is a divergent plate boundary that is found at the floor of the Atlantic Ocean. It is also seen as part of the mountain range in the world. The Mid-Atlantic Ridge also includes a deep rift valley. This rift valley runs along the axis of the ridge. This is along nearly its entire length.

The Andes Mountains is found along the Pacific Ring of Fire. It is seen in a Mesozoic–Tertiary orogenic belt of mountains. The Andes rises due to the compression of the western rim of the South American Plate. It is a result of tectonic plate processes.

San Andreas Fault is known to form the tectonic boundary which exists between the Pacific Plate and the North American Plate. The motion of the fault is right-lateral strike-slip. It divides into three segments.

Answer:

320 grams of sulfur trioxide are required to produce 4.00 mol of sulfuric acid.

Explanation:

The balanced reaction is:

SO₃ + H₂O → H₂SO₄

By reaction stoichiometry (that is, the relationship between the amount of reagents and products in a chemical reaction), the following amounts of moles of each compound participate in the reaction:

Being the molar mass of each compound:

By reaction stoichiometry, the following mass quantities of each compound participate in the reaction:

Then you can apply the following rule of three: if 1 mole of sulfuric acid is produced by the reaction of 80 grams of sulfur trioxide, 4 moles of sulfuric acid is produced from how much mass of sulfur trioxide?

[tex]mass of sulfur trioxide= \frac{4 moles of sulfuric acid* 80 grams of sulfur trioxide}{1 mole of sulfuric acid }[/tex]

mass of sulfur trioxide= 320 grams

320 grams of sulfur trioxide are required to produce 4.00 mol of sulfuric acid.

The mass of the required compound is 320 grams

Given the chemical equation expressed as:

[tex]SO_3 + H_2O \rightarrow H_2SO_4[/tex]

According to stochiometry, 1 mole of SO3  produces 1 mole of H2SO4, hence the moles of SO3 will also be 4.00moles

Determine the mass of SO3

Mass = mole * molar mass

Mass = 4.0 * [32+3(16)]

Mass = 4.0 * 80

Mass = 320 grams

The mass of the required compound is 320 grams

Learn more on stoichiometry here:  https://brainly.com/question/16060223

Answer:

How would you confirm that a colourless liquid given to you is pure water? A very easy solution is to take a sample of the colourless liquid and put it on the stove if it starts boiling exactly at 100 ºC then it is pure water. Any other colourless liquid such as vinegar always has a different boiling point.

[tex] \: \: \: \: \: \: \: \: \: \: \: \: \: \: \: \: \: \: \: \: \red{ \underline{ \large \orange{\tt{ ꧁ A \: N\: S \: W \: E \: R ꧂}}}}[/tex]

✧ [tex] \large{ \red{\tt{E\:X \: O \: T \: H \: E \: R \: M \: I \: C \: \: R \: E \: A \: C \: T\: I \: O \: N}} : }[/tex]

☃ The chemical reaction in which heat is released to the surroundings is called exothermic reaction. The amount of heat energy released is written along with products. This indicates that heat is given out.

[tex] \pink{ \text{Any \: two \: balanced \: equation \: for \: Exothermic \: changes}} : [/tex]

ツ Hope I helped! ♡

☂ Have a wonderful day / night ! ☄

[tex] \underbrace{ \overbrace{ \mathfrak{Carry \: On \: Learning}}}[/tex] ✎

▁▁▁▁▁▁▁▁▁▁▁▁▁▁▁▁▁▁▁▁▁▁▁▁

Answer: i think it is Habitat but i am not 100%

Explanation:

Answer:

Most solar cells are made from silicon—the same semiconductor material that is at the heart of computers. The cells are expensive to produce because it takes a great deal of energy to purify the silicon.

Answer:

C.) Earthquake

Explanation:

Most mountains occur due to the movement of tectonic plates. They slowly push into each other, and the earth's crust rises over time forming mountains.

Earthquakes occur due to the shift of tectonic plates. It sends seismic waves throughout the earth's crust, and causes the ground to shake temporarily.

Answer:

True

Explanation:

Cellular respiration is a metabolic pathway that allows cells to take apart food molecules and use their atoms as an energy source. This pathway takes electrons from food molecules and transfers them to oxygen, has energy transferred to ATP and arranges molecules into water, carbon dioxide and waste.

Answer:

pOH = 1.3, pH = 12.7

Explanation:

Since NaOH is a strong base, it will completely ionize; further, since it completely ionizes, our hydroxide concentration (a product of the ionization) will be the same as the given concentration of NaOH.

NaOH -> Na⁺ + OH⁻, [OH⁻] = 5.0 x 10^-2 M

pOH is the negative log of the hydroxide concentration, so plug our hydroxide concentration in:

pOH = -log[OH⁻] = -log[5.0 x 10^-2 M] = 1.3

Since pH + pOH = 14, we can plug in pOH and solve for pH:

pH + 1.3 = 14

pH = 14 - 1.3 = 12.7

Thus, our pOH = 1.3 and pH = 12.7.

Answer:

2 electrons

Explanation:

The first principal energy level contains only an s sublevel; therefore, it can hold a maximum of two electrons.

Answer:

A

Explanation:

Answer:

Light demonstrates wave-like and particle-like characteristics

Explanation:

Light itself is a wave but under circumstance it will present particle-like charcteristics. This is called wave-particle duality :)

Answer:

2, 2

Explanation

Answer: C. None of these

Explanation: Krypton is a noble gas, on the right side of the period table, making it a non-metal.

Answer:

Mg(s) + Cl₂  -------> MgCl₂

Explanation:

Answer:

Strong acids have mostly ions in solution, therefore the bonds holding H and A together must be weak. Strong acids easily break apart into ions. Weak acids exist mostly as molecules with only a few ions in solution, therefore the bonds holding H and A together must be strong

Answer:

Bond Strength

Explanation:

Strong acids have mostly ions in solution, therefore the bonds holding H and A together must be weak. Strong acids easily break apart into ions. Weak acids exist mostly as molecules with only a few ions in solution, therefore the bonds holding H and A together must be strong.Aug 15, 2020

Answer:

picture is not there.....

Answer:

a

Explanation:

becsaus

AL is aluminum, last, that stuff blows up in microwaves 5

Ag is silver, 3

Ca is calsium 2

Se is a metaloid, Selenium,  4

I is Iodine- first 1