In general, agitation causes the dissolving rate of most solutes to:
A- remain the same
B- increase
C- vary unpredictably
D-decrease

Answer:

your answer for that problem is 34.5

Answer:

The amount of HC₂H3₃2(aq) in the flask after the addition of 5.0mL of NaOH(aq) compared to the amount of HC₂H₃O₂(aq) in the flask after the addition of 1.0mL is much smaller because more HC₂H₃O₂(aq) is required to react with 5.0 mL NaOH than with 1.0 mL NaOH.

Explanation:

Equation of the reaction between acetic acid, HC₂H₃O₂(aq) and sodium hydroxide, NaOH(aq) is given below:

CH₃COOH (aq) + NaOH (aq) ----> CH₃COONa (aq) + H₂O

The equation of the reaction shows that acetic acid andsodium hydroxide will react in a 1:1 ratio

Since the concentration of NaOH was not given, we can assume that the concentration is 0.01 M

Moles of NaOH in 5.0 mL of 0.01 M NaOH = 0.01 × 5/1000 = 0.00005 moles

Moles of NaOH in 1.0 mL of 0.01 M NaOH = 0.01 ×1/1000 = 0.0001 moles

Ratio of moles of NaOH in 5.0 mL to 1.0 mL = 0.00005/0.00001 = 5

There are five times more moles of NaOH in 5.0 mL than in 1.0 mL and this means that 5 times more the quantity of HC₂H₃O2(aq) required to react with 1.0 mL NaoH is needed to react with 5.0 mL NaOH.

Therefore, the amount of HC₂H₃O2(aq) in the flask after the addition of 5.0mL of NaOH(aq) compared to the amount of HC₂H₃O₂(aq) in the flask after the addition of 1.0mL is much smaller because more HC₂H₃O₂(aq) is required to react with 5.0 mL NaOH than with 1.0 mL NaOH.

Explanation:

Answer:

T=PV/nR

Explanation:

PV=nRT then you just move them

Explanation:

Steaming up or fogging happens when steam condenses on the mirror. Steam emerging from hot water can condense on a colder surface. That’s the reason you can see the result on a mirror instantaneously. Obviously, for a bathroom mirror to steam up, the steam that originates at the shower spray (or the bathtub) has to travel through the cooler air to reach the mirror. Since air tends to heat up easily, the mirror can steam up fast.

Answer:

20

Explanation:

not sure please correct me if im wrong

Answer:

20

Explanation:

Got it right on time 4 learning

The answer should be sex cell.

Answer:

1. A

2. C

3. B

4. D

5. D

6. B

Explanation:

I'm not quiet sure on 5 but I'm pretty sure its correct

Answer: Strong acid vs weak acid

Strong acids and strong bases refer to species that completely dissociate to form ions in solution.

Explanation: By contrast, weak acids and bases ionize only partially, and the ionization reaction is reversible. Thus, weak acid and base solutions contain multiple charged and uncharged species in dynamic equilibrium.

Answer:

The correct answer is - A. Ethanol reduces air pollution.

Explanation:

Ethanol is believed to be better fuel for the environment than other petroleum fuels. Ethanol emits lower carbon dioxide as it is clean smokeless fuel, and produces less or the same oxides of nitrogen and hydrocarbons.

It is produced by the process of fermentation of molasses by yeast. Mixing it with the other fuels is found to be CO2 reduces by 30% of emissions to the atmosphere.

Answer:

The volume of the gas is approximately 4.41 liters

Explanation:

The details of the data of the Neon gas are;

The number of moles of Neon gas present, n = 11.6 moles

The temperature of the sample of Neon gas, T = 120 K

The pressure of the sample of the Neon gas, P = 25.6 atm

By the ideal gas equation, we have;

P·V = n·R·T

Where;

R = The universal gal constant = 0.08205 L·atm·mol⁻¹·K⁻¹

Therefore, we get;

V = n·R·T/P

Which gives;

V = 11.6 moles × 0.08205 L·atm·mol⁻¹·K⁻¹ × 120 K/(25.9 atm) ≈ 4.4097915 L

The volume of the gas, V ≈ 4.41 L.

Answer:

V2 = 159.48 mL

Explanation:

Given the following data;

Initial volume = 200 mL

Initial temperature = 28°C

Final temperature = -33°C

To find the final volume, V2, we would use Charles law;

First of all, we would convert the temperature in Celsius to Kelvin.

Mathematically, it is given by the formula;

Kelvin = 273 + C

Substituting into the equation, we have;

Initial temperature, T1:

Kelvin = 273 + 28

Kelvin = 301K

Initial temperature, T1:

Kelvin = 273 - 33

Kelvin = 240K

To find new volume V2, we would use Charles' law.

Charles states that when the pressure of an ideal gas is kept constant, the volume of the gas is directly proportional to the absolute temperature of the gas.

Mathematically, Charles is given by;

[tex] VT = K[/tex]

[tex] \frac{V_{1}}{T_{1}} = \frac{V_{2}}{T_{2}}[/tex]

Where;

V1 and V2 represents the initial and final volumes respectively.

T1 and T2 represents the initial and final temperatures respectively.

[tex] \frac{V1}{T1} = \frac{V2}{T2}[/tex]

Making V2 as the subject formula, we have;

[tex] V_{2}= \frac{V1}{T1} * T_{2}[/tex]

[tex] V_{2}= \frac{200}{301} * 240[/tex]

[tex] V_{2}= 0.6645 * 240 [/tex]

V2 = 159.48 mL

Answer:

When an element replaces another in aone element or ion within a compound is exchanged with another element or ion , the reaction is called 

Answer:

2.33M

Explanation:

1. First, make sure the equation is balanced. In this case it would be HNO3+NaOH --> NaNO3 + H2O. (it is already balanced here.)

2. Find the initial volume, final volume, the volume of acid, volume of NaOH.

      a. Initial Volume: 4.85 mL

      b. Final Volume: 43.69

      c. Acid (HNO3) Volume: 5 mL

      d Volume NaOH: Initial V - Final V --> 43.69 mL - 4.85 mL = 38.84 mL NaOH

3. Find moles of NaOH reacted using the volume from D. Convert this volume into Liters. Multiply the volume of NaOH by molarity of NaOH given to you before. (.30 M NaOH)

      a. x mol NaOH/ .03884 L = .30 mol NaOH/ 1 mol = .011652 mol NaOH

4. Now find the moles of acid. The acid given to you in the equation is HNO3. The .011652 mol NaOH is from the moles reacted that you just found. The moles on the right side would be the co-efficient in front of the elements in the equation. Since this equation does not have any coefficients (it's already balanced), it would just be 1.

      a.  .011652 mol NaOH/ x mol HNO3 = 1 mol NaOH/ 1 mol HNO3.

                       x = .011652 mol HNO3

5. Now find the concentration, also known as molarity. Divide the .011652 mol by the volume of acid you have been given (5 mL). Before using 5 mL, divide it by 1000 to get the Liter form.

     a. .011652 mol HNO3/ .005 L = 2.3304 M HNO3

I hope you understand now. God bless!

Answer:

D: Increase of pressure

The reactant necessary for a combustion reaction is oxygen.

(option D).

Combustion is a chemical reaction that occurs when a substance reacts with oxygen, producing heat and light. In order for combustion to take place, three elements are needed: fuel, heat, and oxygen.
Fuel is the substance that undergoes combustion, such as gasoline, wood, or methane. Heat is the energy required to initiate and sustain the reaction. Lastly, oxygen is the reactant that combines with the fuel, allowing it to burn and release energy.
When a combustion reaction occurs, the fuel and oxygen combine to form carbon dioxide (option C) and water (option A). This process is exothermic, meaning it releases energy in the form of heat and light.
For example, when wood is burned in the presence of oxygen, it undergoes combustion. The heat from a match or a spark provides the necessary activation energy to start the reaction. Oxygen from the air combines with the carbon in the wood, producing carbon dioxide and releasing energy in the form of heat and light.
In summary, oxygen is the reactant necessary for a combustion reaction. It combines with the fuel and releases energy in the form of heat and light.

(option D).

For more such questions on combustion reaction

https://brainly.com/question/13251946

#SPJ8

Answer:I think it would be D.

Explanation:The law of conservation of mass states that matter cannot be created or destroyed in a chemical reaction. For example, when wood burns, the mass of the soot, ashes, and gases equals the original mass of the charcoal and the oxygen when it first reacted. So the mass of the product equals the mass of the reactant.

Answer:

[tex]m_{Fe_2O_3}=549gFe_2O_3[/tex]

Explanation:

Hello there!

In this case, according to the given chemical reaction for this problem about stoichiometry:

[tex]4Fe+3O_2\rightarrow 2Fe_2O_3[/tex]

Whereas there is a 3:2 mole ratio of oxygen (molar mass = 32.0 g/mol) to iron (III) oxide (molar mass = 159.69 g/mol) and therefore, the correct stoichiometric setup is:

[tex]m_{Fe_2O_3}=165gO_2*\frac{1molO_2}{32.00gO_2}*\frac{2molFe_2O_3}{3molO_2} *\frac{159.69gFe_2O_3}{1molFe_2O_3} \\\\m_{Fe_2O_3}=549gFe_2O_3[/tex]

Regards!

Answer: As a result an increase in kinetic energy also happens.

Explanation:

Potential energy is the energy occupied by an object or substance due to its position.

Kinetic energy is the energy occupied by an object of substance due to its motion.

If the kinetic and potential energy in a system are equal and then an increase in potential energy will occur.

As a  result, there will also occur an increase in kinetic energy also.

Thus, we can conclude that as a result an increase in kinetic energy also happens.

Answer:

Evolution in the broadest sense explains that what we see today is different from what existed in the past. Galaxies, stars, the solar system, and earth have changed through time, and so has life on earth.Something that happened in the past is thus not "off limits" for scientific study. Hypotheses can be made about such phenomena, and these hypotheses can be tested and can lead to solid conclusions. Furthermore, many key aspects of evolution occur in relatively short periods that can be observed directly—such as the evolution in bacteria of resistance to antibiotics.Laws, like facts and theories, can change with better data. But theories do not develop into laws with the accumulation of evidence. Rather, theories are the goal of science.

Explanation:

Answer: the answer is A

Explanation:

Answer:

The answer to your question is, A. consumer.

Explanation:

Any organism that 'consumes' other organisms is a consumer

Answer:

1.03 M

Explanation:

Step 1: Write the balanced equation

NaOH + HCl ⇒ NaCl + H₂O

Step 2: Calculate the reacting moles of HCl

30.0 mL (0.0300 L) of 0.500 M HCl react.

0.0300 L × 0.500 mol/L = 0.0150 mol

Step 3: Calculate the moles of NaOH that react with 0.0150 moles of HCl

The molar ratio of NaOH to HCl is 1:1. The moles of NaOH that react are 1/1 × 0.0150 mol = 0.0150 mol.

Step 4: Calculate the molar concentration of NaOH

0.0150 moles of NaOH are in 14.5 mL (0.0145 L).

M = 0.0150 mol/0.0145 L = 1.03 M

Answer:

B). The smallest part of matter still retaining chemical properties.

[tex]methane \: reacts \: with \: oxygen [/tex]

CH4 + 2O2 → CO2 + 2H2O.

Step-by-step explanation

L.H.S.

C = 1, H = 4, O = 2×2 = 4.

R.H.S

C = 1, O = 2, H = 2×2= 4, O = 2.

Answer:

The sexual phase, called the gametophyte generation, produces gametes, or sex cells, and the asexual phase, or sporophyte generation, produces spores asexually. In terms of chromosomes, the gametophyte is haploid (has a single set of chromosomes), and the sporophyte is diploid (has a double set

Answer:

Gametophyte generation