Answer:
b I think it is the correct answer
Electrolysis Is One of the Modern Technologies in Architecture’ Prepare an Investigatory Report That Supports the Statement”.
Electrolysis is a technique that separates natural elements. It is commercially used to obtain important materials (e.g., pure metals) for construction.
Electrolysis refers to the use of an electric current to trigger non-spontaneous chemical reactions.
This technology (electrolysis) is commercially important in industry, construction and therefore also in architecture in order to extract metals and minerals from the ground.
Electrolysis uses particular electrolytic cells in order to extract highly pure metals from ores.
Learn more about electrolysis here:
https://brainly.com/question/12054569
Answer: Electrolysis is a technique that separates natural elements. It is commercially used to obtain important materials (e.g., pure metals) for construction.
Electrolysis refers to the use of an electric current to trigger non-spontaneous chemical reactions.
This technology (electrolysis) is commercially important in industry, construction and therefore also in architecture in order to extract metals and minerals from the ground.
Electrolysis uses particular electrolytic cells in order to extract highly pure metals from ores.
Learn more about electrolysis here:
brainly.com/question/12054569
4. The new element Plainsmenium (Pe) was discovered in 2005 by Monte E. Rey
(who will receive his Nobel Prize in Chemistry in the year 2012). It has
three isotopes: Pe-184 (24.60%), Pe-185 (11.20%), and Pe-188 (64.20%).
What is its average atomic mass?
This is my answer
Explanation:
p=m/v
where:. p=density
m=mass
v=volume
p=F/A = Lim ∆F / ∆A
1 ATM=14.7 psi
= 1.013x10⁶ d/cm²
1 bar=10⁶ d/cm²
=10⁵ N/m2
Hope it helps to you goodluck
I'm not sure but that's the answer of my notebook like my answer please
Safety considerations
• Sodium Hydroxide (please insert one statement of caution from MSDS)
Answer:
d took the test
Explanation:
The F-C-F bond angle in the CH2F2 molecule is approximately __________.
Group of answer choices
180°
90°
120°
60°
109.5°
Answer:
109.5°
Explanation:
Pls Cross Check It, If It Correct
Consider the gas phase reaction 4HCl + O2 → 2Cl2 + 2H2O. What volume of chlorine gas at STP can be prepared from the reaction of 600. mL of gaseous HCl, measured at STP, with excess oxygen?
a. 150 mL b. 267 mL c. 300 mL d. 425 mL e. 600 mL
Answer:
c
Explanation:
What makes a cyclone rotate counter-clockwise north of the Equator and clockwise south of the Equator?
1 Ocean currents
2 Coriolis Effect
3 the Jet Stream
4 Landscape differences
The Coriolis Effect (Core-nol-e-us)
What is the most soluble in water? iconic, covalent, metallic or nonmetallic
How many teaspoons are equal to 1 mole of water if there is 0.23 teaspoon for every 1 g?
A. 0.46 teaspoon
B. 3.68 teaspoons
C. 4.14 teaspoons
D. 18 teaspoons
Answer:it's b hope that help
The molar mass of water is 18 g. Given that there are 0.23 teaspoon for every 1 g. Thus , for 18 g there would be 4.14 teaspoons.
What is one mole?Any substance that contains 6.022 × 10²³ number of atoms is called one mole of that substance. The mass of a compound or molecule containing these much atoms is called its molar mass.
Molar mass of water is 18 g. Thus, it means that one mole of water weighs 18 g. Given that for every 1 g of water there are 0.23 teaspoon. Thus, number of teaspoons for one mole or 18 g of water is:
number of teaspoons = 18 g × 0.23 /1 g
= 4.14 teaspoons.
Therefore, 4.14 teaspoons are required for one mole of water.
To find more on molar mass, refer here:
https://brainly.com/question/12127540
#SPJ6
A 6.00 L container of N_2 has a temperature of 273 K. Calculate the volume if the temperature is doubled.
a
24.0 L
b
12.0 L
c
6.0 L
d
3.0 L
1. How many atoms are in 1.00 mole of H?
Answer:
6.022 × 1023
Explanation:
1 mole of H:
The definition of Avogadro's number of 6.022 × 1023/mole is the number of atoms or molecules per one gram atomic weight. For one gram atomic weight of hydrogen with an atomic weight of one gram, one mole of hydrogen contains 6.022 × 1023 hydrogen atoms. 1.45⋅6.02⋅1023≈8.73⋅1023 hydrogen atoms.
1 mole:
The value of the mole is equal to the number of atoms in exactly 12 grams of pure carbon-12. 12.00 g C-12 = 1 mol C-12 atoms = 6.022 × 1023 atoms • The number of particles in 1 mole is called Avogadro's Number (6.0221421 x 1023).
in an H:
H: 2×2×4=16 atoms of hydrogen. C: It only appears once and without a subscript, so 1×4=4 . O : Like carbon, it's 1×4=4 .
1.00 mole:
One mole is equal to 6.02214179×1023 atoms, or other elementary units such as molecules.
Mark me brinilylist
what is the mass in g of 7.009 x 10^21 molecules of Pl3?
0.1216 g
wire
All
g
of
20 mL of 1M HCl
neutralized by addition of 50 mL of 0.20 M NaoH
Find the Atomic mass of Mg ?
added
magnisium was added
the excess
acid
was
Keep Scrolling! :D
[tex] \rule{999pt}{66646pt}[/tex]
Please give help and label them giving brainiest
Answer:
huh
Explanation:
please help
write the correct IUPAC name for these componds
Answer:
A. 4,6-dimethyloct-1,4,6-yne
B. deconic acid
C. 3-ethyl-4-methyl-7-bromocyclohexene
D. 2,2,3-trimethyl-4-butyl-heptane
E. 3-methylhexane
F. ethyl hexanoate
G. butanal
H. propyne
J. 2,4-dimethyl-pent-2-ene
Explanation:
sorry i didn't have time to do I
How does the water cycle contribute to the "brown ocean" effect?
Answer:
Hurricanes and tropical storms gain their power from heated water evaporating from the ocean.
Explanation:
Brown Water Effect The brown ocean effect is an observed weather phenomenon involving some tropical cyclones after landfall. Normally, hurricanes and tropical storms lose strength when they make landfall, but when the brown ocean effect is in play, tropical cyclones maintain strength or even intensify over land surfaces.How how how how how
Hello Americans greetings from the Philippines
Answer:
good day philipines
Explanation:
Answer:
hello
Explanation:
Some insects, such as water striders, are able to walk on water. In one or two sentences, make and justify a conjecture about a property of water that would allow the insect to walk on it.(2 points) SHORT ANSWER
Insects can walk on water due to its surface tension, which is something like 0.07 J/m^2.
So water (and most liquids) have a property called surface tension, which is defined as the amount of energy that you need to increase the surface per area unit of the liquid volume.
Thus, if the insect has smaller energy than that, it would not change the surface of the liquid, allowing it to walk on the water's surface.
If you want to learn more about surface tension, you can read:
https://brainly.com/question/11348644
Answer: They are able to walk on water because of surface tension. Liquid molecules are held together by electrostatic forces. Molecules on the surface of the water are attracted to surrounding molecules and tension is created as the molecules get pulled down. This allows them to distribute their body weight over the water’s surface without breaking through that force.
Explanation:
define conjugate Base and conjugate acid
Explanation:
conjugated base is substance formed when an acid loses
a hydrogen ion.
conjugated acid is a type of acid that is formed when a base accepts a proton in solution
I have a hard time telling the difference between convection, conduction, and radiation, anybody got any tips?
natural gas has been stored in an expandable tank that keeps a constant pressure as gas is added or removed. the tank has a volume of 4.50x 104 ft 3 when it contains 77.4 million mole natural gas at - 5 °c. what is the new volume of the tank if consumers use up 5.3 million mole and temperature increase to 7 °c?
Answer:
5-3. Ice water 0 "C. A steel tank contains carbon dioxide at 27 "C and a pressure of 12.0 atm.
Explanation:
Which element is shown below? How do you know?
Which of these objects will most likely float?
Answer:
plastic,palstic bottle,balloon,cap of water bottle,plastic slippers and plastic comb.
Explanation:
hope it helps :D
calculate the number of molecules in 4.48dm3 of hydrogen at STP
Answer: 1 more of hydrogen =22.4dm3
X moles of hydrogen =4.48dm3
22.4dm3x = 4.48dm3
4.48dm3\22.4dm3
X=0.2 moles
Explanation: 1 volume of hydrogen at STP is 22.4dm3
Gaseous methane reacts with gaseous oxygen gas to produce gaseous carbon dioxide and gaseous water. If 0.809g of carbon dioxide is produced from the reaction of 0.80g of methane and 2.1g of oxygen gas, calculate the percent yield of carbon dioxide.
Be sure your answer has the correct number of significant digits in it.
Answer:
About 58%.
Explanation:
We first need to write the balanced chemical equation:
[tex]\displaystyle \text{CH$_4$(g)} + 2\text{O$_2$(g)} \longrightarrow \text{CO$_2$(g)} + 2\text{H$_2$O(g)}[/tex]
We are given that 0.809 g of carbon dioxide was produced from the reaction of 0.80 g of methane and 2.1 g of oxygen gas. We want to calculate the percent yield of carbon dioxide.
First, determine the limiting reagent. We can convert each initial mass to the mass of carbon dioxide using stoichiometry. The molar mass of methane is 16.05 g/mol and the molar mass of carbon dioxie is 44.01 g/mol. From the equation, every one mole of carbon dioxide is produced from every one mole of methane and every two moles of oxygen gas.
0.80 g of methane will (theoretically) produce:
[tex]\displaystyle \begin{aligned} 0.80 \text{ g CH$_4$} &\cdot \frac{1 \text{ mol CH$_4$}}{16.05 \text{ g CH$_4$}} \cdot \frac{1 \text{ mol CO$_2$}}{1 \text{ mol CH$_4$}} \cdot \frac{44.01 \text{ g CO$_2$}}{1 \text{ mol CO$_2$}} \\ \\ & = 2.2 \text{ g CO$_2$}\end{aligned}[/tex]
2.1 g of oxygen gas will (theoretically) produce:
[tex]\displaystyle \begin{aligned} 2.1 \text{ g O$_2$} & \cdot \frac{ 1 \text{ mol O$_2$}}{32.00 \text{ g O$_2$}} \cdot \frac{1 \text{ mol CO$_2$}}{2 \text{ mol O$_2$}}\cdot \frac{44.01 \text{ g CO$_2$}}{1 \text{ mol CO$_2$}} \\ \\ & = 1.4 \text{ g CO$_2$} \end{aligned}[/tex]
Hence, oxygen gas is the limiting reagent. A maximum of 1.4 g of carbon dioxide can be produced.
To calculate the percent yield, we divide the actual yield by the theoretical yield. The actual yield was 0.809 g and the theoretical yield is 1.4 g. Hence:
[tex]\displaystyle \begin{aligned} \%\text{Yield} & = \frac{\text{Actual}}{\text{Theoretical}} \times 100\% \\ \\ & = \frac{(0.809\text{ g CO$_2$})}{(1.4\text{ g CO$_2$})} \times 100\% \\ \\ & = 58\%\end{aligned}[/tex]
In conclusion, the percent yield of carbon dioxide is about 58%.
Please help due tomorrow
Answer:
The gravitational force at the center of the Earth is 0.
what is metal's I need answer
Answer:
objects thaty release 0H+ and H- ions when dissociated
Explanation:
in chemistry
please mark brainliest
what is the correct sequence of stages in cellular respiration
Answer:
Explanation:
Glycolysis
Pyruvic acid oxidation
Curbs cycle or citric acid cycle.
Respiratory chain.
Have a great night!
1. How does the figure below illustrate Hund's rule?
Answer:
it indicates that the lower orbitals are filled first and they have the maximum number of electrons compared to the higher orbitals
write the conjugate bases of the following acids ? H₂S , HCOOH ,HSO₃¯ , HSO¯₄ , HS¯, HNO₂ ,HCN,?
Answer:
HS(-)
HCOO(-)
SO3(2-)
SO4(2-)
S(2-)
NO2(-)
CN(-)
Explanation:
The parenthesis are the charges of the compounds. When an acid is introduced in a base, it dissociates its Hydrogens giving protons to the base. In this case, if you remove one hydrogen of a compound, you will reduce the charge of a compound since basically you're removing a positive charge from a compound. If you need to, I can explain how the thing of the charges work.
In fact, the definition of a conjugate base is a compound created when the original (an acid) compound dissacioate an atom of hydrogen (a proton) in a base.
Why do we feel cold when we touch the iron?
A) Heat flows from iron to our body.
B) Heat flows from our body to iron.
C) Heat flows from iron to iron
D) Heat does not not flow
Please answer it soon as possible
Heat flows from our body to iron